** This information is given in good faith, but no warranty, expressed or implied is made. |
|||||
MATERIAL SAFETY DATA SHEET |
CERROLOW 117-4470-2 | ||||
CAKES |
|||||
| LOW MELT ALLOYS | |||||
SECTION 1: IDENTIFICATION |
|||||
Furnished by: |
Grant Manufacturing & Alloying, Inc |
||||
200-C Furnace Street |
|||||
| Birdsboro, Pa 19508 | |||||
Effective Date: |
01/01/01 |
||||
Emergency Phone Number: |
610-404-1380 |
||||
Person to Contact: |
David Charest |
||||
SECTION 2: CONSTITIUENTS |
|||||
CHEMICAL |
CAS# |
%WT |
Carcinogen | OSHA PERMISSIBLE EXPOSURE LIMIT-8 HOUR TWA | ACGIH THRESHOLD LIMIT VALUE - 8 HOUR LIMIT |
BISMUTH |
7440-69-9 |
50.00 |
no | N/A |
N/A |
LEAD |
7439-92-1 |
26.70 |
yes |
0.05 MG/M3 | 0.15/M3 |
TIN |
7440-31-5 |
13.30 |
no | 2MG/M3 | 2MG/M3 |
CADMIUM |
7440-43-9 |
10.00 |
yes |
0.005MG/M3 | 0.01MG/M3 TOTAL DUST PART. |
INDIUM |
7440-31-5 |
19.10 |
NO |
0.1 MG/M3 | 0.1 MG/M3 |
SECTION 3: PHYSICAL DATA |
|||||
Melting Point |
117 F |
||||
Boiling Point |
N/A |
||||
Vapor Pressure |
N/A | ||||
Vapor Density |
0.320 /LB CU IN | ||||
Solubility in Water |
nil |
||||
Apperance/Color |
METALLIC gray | ||||
Odor |
none |
||||
% Volatile |
nil |
||||
pH |
n/ap |
||||
Evaporation Rate |
n/ap |
||||
| CAUTION: NEVER USE WATER AS AN EXTINGUSHING MEDIA IN AREAS NEAR MOLTEN METAL | |||||
SECTION 4: FIRE AND EXPLOSION HAZARD DATA |
|||||
Flash Point |
N/A | ||||
Flammable Limits |
n/ap |
||||
Extinguishing Methods |
n/ap |
||||
Fire Fighting Equipment |
If metal is present where there is fire, wear self contained breathing device in case lead fumes. |
||||
SECTION 5: REACTIVITY DATA |
|||||
Stability |
stable |
||||
Conditions to Avoid |
n/ap |
||||
Hazardous Polymerization |
will not occur |
||||
Incompatibility |
strong acids, reducing agents, halogens and oxidizers |
||||
Hazardous Decomposition |
lead fumes at high temperatures (above 750 F) |
||||
SECTION 6: SPILL, LEAK AND DISPOSAL PROCEDURES |
|||||
Actions to take for spills |
allow to solidify, collect and place in sealed drum |
||||
Disposal Method |
Scrap alloy can be reclaimed for reuse. follow federal, state and local regs. | ||||
SECTION 7: HEALTH HAZARD INFORMATION |
|||||
Eye |
dust or fumes will be an irritant |
||||
Skin Contact |
not a route of entry to the body |
||||
Skin Absorption |
not a route of entry to the body |
||||
Ingestion |
Ingestion of lead dust or fumes must be avoided. Lead is toxic and cumulative, affecting the kidneys and nervous system. Symptons will include anemia, insomnia, weakness, irritability,constipation and stomach pains.Tin is not regarded as toxic, but excessive exposure can cause fever, nausea, diarrhea and stomach cramps. |
||||
| Section 8: First Aid Procedures | |||||
| Eyes: | Flush thoroughly with water and call a physician. | ||||
| Skin: | Wash thoroughly with soap and water. | ||||
| Ingestion: | Induce vomiting if person is conscious. Call a physician. | ||||
| Inhalation: | Remove to fresh air. Call a physician. | ||||
| Note to Physician: | |||||
| Section 9: Special Handling Information | |||||
| Ventilation: | Required to maintain TLV's | ||||
| Respiratory Protection: | Fume Mask required. | ||||
| Eye Protection: | Wear protective goggles. | ||||
| Skin Protection: | Use protective gloves when handling material. | ||||
| Other: | N/A | ||||
| Section 10: Special Procautions & Additional Information | |||||
| Storage: | Store metal in clean dry area, away from heat and chemicals that might react with the material. | ||||
| Section 11: Hazard Rating | |||||
| Based on NFPA and NPCA Systems | |||||
| Health-2 | |||||
| Flammability-0 | |||||
| Reactivity-0 | |||||
| Special Hazzard-W | |||||
| END: | |||||